Linux version 2.4.19-64-smp (root@j5k) (gcc version 3.0.4) #1 SMP Sun Oct 20 12:28:08 MDT 2002 FP[0] enabled: Rev 1 Model 16 The 64-bit Kernel has started... Determining PDC firmware type: System Map. model 00005bd0 00000491 00000000 00000002 780cd540 100000f0 00000008 000000b2 000000b2 vers 00000201 CPUID vers 17 rev 5 (0x00000225) capabilities 0x3 model 9000/785/J5000 Total Memory: 1024 Mb pagetable_init On node 0 totalpages: 262144 zone(0): 262144 pages. zone(1): 0 pages. zone(2): 0 pages. LCD display at fffffff0f05d0008,fffffff0f05d0000 registered Kernel command line: root=/dev/sda4 HOME=/ console=ttyS0 TERM=vt102 palo_kernel=2/vmlinux Console: colour dummy device 160x64 Calibrating delay loop... 878.18 BogoMIPS Memory: 1018584k available Dentry cache hash table entries: 131072 (order: 9, 2097152 bytes) Inode cache hash table entries: 65536 (order: 8, 1048576 bytes) Mount-cache hash table entries: 16384 (order: 6, 262144 bytes) Buffer-cache hash table entries: 65536 (order: 7, 524288 bytes) Page-cache hash table entries: 262144 (order: 9, 2097152 bytes) Searching for devices... Found devices: 1. Astro BC Runway Port (12) at 0xfffffffffed00000 [10], versions 0x582, 0x0, 0xb 2. Elroy PCI Bridge (13) at 0xfffffffffed30000 [10/0], versions 0x782, 0x0, 0xa 3. Elroy PCI Bridge (13) at 0xfffffffffed32000 [10/1], versions 0x782, 0x0, 0xa 4. Elroy PCI Bridge (13) at 0xfffffffffed34000 [10/2], versions 0x782, 0x0, 0xa 5. Elroy PCI Bridge (13) at 0xfffffffffed38000 [10/4], versions 0x782, 0x0, 0xa 6. Elroy PCI Bridge (13) at 0xfffffffffed3c000 [10/6], versions 0x782, 0x0, 0xa 7. Forte W 2-way (0) at 0xfffffffffffa0000 [32], versions 0x5bd, 0x0, 0x4 8. Forte W 2-way (0) at 0xfffffffffffa2000 [34], versions 0x5bd, 0x0, 0x4 9. Memory (1) at 0xfffffffffed10200 [49], versions 0x88, 0x0, 0x9 CPU(s): 2 x PA8500 (PCX-W) at 440.000000 MHz SBA found Astro 2.1 at 0xfffffffffed00000 lba version TR2.1 (0x2) found at 0xfffffffffed30000 WARNING: Ignoring enabled ELMMIO BASE 0xf8000000 SIZE 0xfc000000 lba version TR2.1 (0x2) found at 0xfffffffffed32000 WARNING: Ignoring enabled ELMMIO BASE 0xf8000000 SIZE 0xfc000000 lba version TR2.1 (0x2) found at 0xfffffffffed34000 WARNING: Ignoring enabled ELMMIO BASE 0xf8000000 SIZE 0xfc000000 lba version TR2.1 (0x2) found at 0xfffffffffed38000 WARNING: Ignoring enabled ELMMIO BASE 0xf8000000 SIZE 0xfc000000 lba version TR2.1 (0x2) found at 0xfffffffffed3c000 WARNING: Ignoring enabled ELMMIO BASE 0xf8000000 SIZE 0xfc000000 POSIX conformance testing by UNIFIX SMP: bootstrap CPU ID is 0 FP[1] enabled: Rev 1 Model 16 SMP: Total 2 of 2 processors activated (1756.36 BogoMIPS noticed). Waiting on wait_init_idle (map = 0x2) All processors have done init_idle Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Soft power switch enabled, polling @ 0xfffffff0f0400804. Performance monitoring counters enabled for Forte W 2-way Starting kswapd Journalled Block Device driver loaded Installing knfsd (copyright (C) 1996 okir@monad.swb.de). STI GSC/PCI graphics driver version 0.9 pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled SuperIO: Found NS87560 Legacy I/O device at 00:0e.1 (IRQ 128) SuperIO: Serial port 1 at 0x3f8 SuperIO: Serial port 2 at 0x2f8 SuperIO: Parallel port at 0x378 SuperIO: Floppy controller at 0x3f0 SuperIO: ACPI at 0x7e0 SuperIO: USB regulator enabled ttyS00 at port 0x03f8 (irq = 195) is a 16550A ttyS01 at port 0x02f8 (irq = 196) is a 16550A lp: driver loaded but no devices found Generic RTC Driver v1.02 05/27/1999 Sam Creasey (sammy@oh.verio.com) Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx NS87415: IDE controller on PCI bus 00 dev 70 NS87415: chipset revision 3 NS87415: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x0a00-0x0a07, BIOS settings: hda:pio, hdb:pio ide1: BM-DMA at 0x0a08-0x0a0f, BIOS settings: hdc:pio, hdd:pio hda: HITACHI CDR-8435, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 199 hda: ATAPI 32X CD-ROM drive, 128kB Cache Uniform CD-ROM driver Revision: 3.12 RAMDISK driver initialized: 16 RAM disks of 6144K size 1024 blocksize loop: loaded (max 8 devices) Linux Tulip driver version 0.9.15-pre11 (May 11, 2002) tulip0: no phy info, aborting mtable build tulip0: MII transceiver #1 config 1000 status 782d advertising 01e1. eth0: Digital DS21143 Tulip rev 48 at 0x1000, 00:10:83:04:14:7D, IRQ 130. SCSI subsystem driver Revision: 1.00 sym53c8xx: at PCI bus 0, device 15, function 0 sym53c8xx: 53c896 detected sym53c8xx: at PCI bus 0, device 15, function 1 sym53c8xx: 53c896 detected sym53c896-0: rev 0x4 on pci bus 0 device 15 function 0 irq 129 sym53c896-0: ID 7, Fast-20, Parity Checking sym53c896-0: handling phase mismatch from SCRIPTS. sym53c896-1: rev 0x4 on pci bus 0 device 15 function 1 irq 129 sym53c896-1: ID 7, Fast-40, Parity Checking sym53c896-1: handling phase mismatch from SCRIPTS. scsi0 : sym53c8xx-1.7.3c-20010512 scsi1 : sym53c8xx-1.7.3c-20010512 Vendor: SEAGATE Model: ST39102LC Rev: 7C03 Type: Direct-Access ANSI SCSI revision: 02 Vendor: SEAGATE Model: ST39102LC Rev: 7C03 Type: Direct-Access ANSI SCSI revision: 02 Vendor: SEAGATE Model: ST118202LC Rev: 7D04 Type: Direct-Access ANSI SCSI revision: 02 Vendor: SEAGATE Model: ST39102LC Rev: HP01 Type: Direct-Access ANSI SCSI revision: 02 Attached scsi disk sda at scsi1, channel 0, id 3, lun 0 Attached scsi disk sdb at scsi1, channel 0, id 4, lun 0 Attached scsi disk sdc at scsi1, channel 0, id 5, lun 0 Attached scsi disk sdd at scsi1, channel 0, id 6, lun 0 sym53c896-1-<3,*>: FAST-20 WIDE SCSI 40.0 MB/s (50.0 ns, offset 15) SCSI device sda: 17781521 512-byte hdwr sectors (9104 MB) Partition check: sda: sda1 sda2 sda3 sda4 sym53c896-1-<4,*>: FAST-20 WIDE SCSI 40.0 MB/s (50.0 ns, offset 15) SCSI device sdb: 17781521 512-byte hdwr sectors (9104 MB) sdb: sdb1 sym53c896-1-<5,*>: FAST-20 WIDE SCSI 40.0 MB/s (50.0 ns, offset 15) SCSI device sdc: 35566480 512-byte hdwr sectors (18210 MB) sdc: sdc1 sym53c896-1-<6,*>: FAST-20 WIDE SCSI 40.0 MB/s (50.0 ns, offset 15) SCSI device sdd: 17773524 512-byte hdwr sectors (9100 MB) sdd: sdd1 STI GSC/PCI graphics driver version 0.9 BUG: Skipping previously registered driver: sti (native) usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb-ohci.c: USB OHCI at membase 0xfffffffff4007000, IRQ 193 usb-ohci.c: usb-00:0e.2, National Semiconductor Corporation USB Controller usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 3 ports detected usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers mice: PS/2 mouse device common for all mice HP SDC: No SDC found. HP SDC MLC: Registering the System Domain Controller's HIL MLC. HP SDC MLC: Request for raw HIL ISR hook denied md: linear personality registered as nr 1 md: raid0 personality registered as nr 2 md: raid1 personality registered as nr 3 md: raid5 personality registered as nr 4 raid5: measuring checksumming speed 8regs : 1995.200 MB/sec 8regs_prefetch: 1636.800 MB/sec 32regs : 1651.600 MB/sec 32regs_prefetch: 1549.200 MB/sec raid5: using function: 8regs (1995.200 MB/sec) md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 48Kbytes TCP: Hash tables configured (established 32768 bind 65536) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. EXT3-fs: INFO: recovery required on readonly filesystem. EXT3-fs: write access will be enabled during recovery. kjournald starting. Commit interval 5 seconds EXT3-fs: sd(8,4): orphan cleanup on readonly fs ext3_orphan_cleanup: deleting unreferenced inode 194709 ext3_orphan_cleanup: deleting unreferenced inode 194696 EXT3-fs: sd(8,4): 2 orphan inodes deleted EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 326k freed Adding Swap: 1990648k swap-space (priority -1) EXT3 FS 2.4-0.9.17, 10 Jan 2002 on sd(8,4), internal journal kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.17, 10 Jan 2002 on sd(8,2), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.17, 10 Jan 2002 on sd(8,17), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.17, 10 Jan 2002 on sd(8,33), internal journal EXT3-fs: mounted filesystem with ordered data mode. eth0: Setting full-duplex based on MII#1 link partner capability of 41e1.